3 in 1 diversified use: Bluetooth earphone & Safety Hammer & Car USB Quick Charger.
Bluetooth V4.0 technology: More rapid transmission.
Bluetooth earphone detachable, more convenient of use.
Built-in Microphone, supports hands-free calls: Answer phone automatically when pick up the earphone from the car charger; and hang up automatically when put the earphone back on the car charger.
Using intelligent identification IC, Output 2.4A current stablely, as fast charge 3.0 standard.
USB outputs, enrich your needs, It can charge for 5V devices, such as charger for iPhone, iPad, Samsung, HTC, Sony, Lenovo, Huawei, Xiaomi and other Smartphones or Tablet, MP3, MP4, etc.
It can be used as emergency hammer to break the car window glass because of the solid stainless steel + zinc alloy material, solid and sharp iron and steel construction.
HQX6 Car Bluetooth Music Receiver (Hands-free) is a high-tech wireless product that can receive music on a mobile phone or TF card or a Bluetooth-enabled transmitter.
This music receiver can be used for almost all audio receivers with input plugs, including automotive devices. You can receive music from your Smartphone and MP3 at the home's speakers or the car's sound system.
The product with an embedded echo cancellation microphone, only a button can be easily in the music and telephone switch between.
Car Spark Plug Tester Detector with Dual Hole Advantage: Dual Hole Car Spark Plug Tester Detector have two testing holes, you can test two spark plugs meanwhile and and if you suspect any spark plug works improperly you could compare and test to make accurate judgment.
Usage: Test spark plug performance and ignition strength.
Application Range: 12V Gasoline vehicles car spark plugs.
Principle:
In automobile ignition system, the high-voltage ignition coil generates a high-voltage (10000 volts or more), and the spark plug diverts it form.
High-tension ignition coil into the cylinder engine, spark between the spark plug electrodes will ignite the mixture. The Detector could tell the good spark plugs from the bad by the strength of the spark.
Using Note:
Please Turn Off Power before you place spark plug.
Easy to install and looks clean on your dash panel.
Built-in light sensor, this LED light will flash in nighttime and will not flash in daytime. (You can cover the other end by dark paper if you want it to flash in daytime.)
This LED alarm light does NOT require a car alarm system.
No wires needed, just stick it to the roof of the vehicle with corresponding glue.
Solar energy can be absorbed and saved in high efficiency solar cells.
Do not need to install battery. It's powered by solar. It can blink for whole night after enough sun shining in daytime.
You need not put it under sunshine directly. Sunshine above the dashboard is enough.
2-pin Electronic LED 12V Flasher Relay for most Honda, Kawasaki, Yamaha motorcycles; Fix for Turn Signal, Hyper Flashing, Blinker LED Light.
Easy Plug & Play installation; Waterproof design in solid-state efficient unit with no excess heat issue.
This Flasher Relay Controller will solve LED Light related turn signal blinker problems such as hyper fast flashing, not flashing, or light bulb burnt out warning.
Message on dashboard indicator or just replace bad relay.
It can eliminate the usage of load resistor, direct OEM replace any two-wire 2-pin flasher relay and operate with LED's or conventional bulbs at normal OEM flash rate.